# 25, things are getting easier

# 28 or so

Almost ready...

Here the trick with the clamps and rope to twist the strip don't work anymore. I can't get the clamps in between the hog and the strip.

Since the tension is still rather high, the strips want to move from the moulds away.
Using screws and big rings to get them against the moulds does work BUT after you remove them you will find terrible holes at the size of the ring. You do not want this because it is a lot of work the get the surface flat again.

I used some short pieces of obsolete strips, screwed them into the previous strip and used a clamp to pull the other end towards the hog. this way you can dose very precisely how much the new strip should bend.

One more to go.